TYRE SERVICE SCISSOR LIFT · 3 TONNES
3 Tonne Tyre Service Scissor Car Lift 220 V EQT-30SSE-220
Professional mid-rise electrohydraulic scissor lift designed for tyre service centres, fast-fit workshops and vehicle maintenance. With a maximum lifting capacity of 3,000 kg and 220 V single-phase power supply, it lifts vehicles up to 960 mm to provide easier access for tyre changes, wheel servicing, brake work and other maintenance tasks. Equipped with synchronised hydraulic cylinders, precision safety locks, hydraulic protection, a lowering safety alarm and four included rubber lifting pads.
✓ Designed for tyre changes and fast-fit work: the 960 mm lifting height supports convenient access to wheels, tyres, brakes and other service components without needing a full-height vehicle lift.
✓ 3 tonne lifting capacity: suitable for passenger cars and other compatible vehicles within the 3,000 kg rated capacity, subject to approved support points and correct load distribution.
✓ Low profile and supporting platforms: published minimum height of 110 mm and platform length of 2,050 mm make this a practical option for compact tyre and service bays.
✓ Synchronised electrohydraulic lifting: synchronised hydraulic cylinders coordinate movement during lifting and lowering operations.
✓ Precision safety locking: retaining mechanisms support the lift in its designated working positions when operated in accordance with the manufacturer's instructions.
✓ Hydraulic and lowering protection: hydraulic circuit protection valve, safety stop and alarm during lowering, plus an upper limit switch.
✓ Four rubber lifting pads included: pads support the vehicle at approved lifting locations while reducing direct contact with the lifting platforms.
Recommended applications
- Tyre and wheel replacement.
- Tyre service centres and fast-fit workshops.
- Brake inspections and repairs.
- Mid-rise vehicle maintenance.
- Visual inspection of accessible underbody components.
- Workshops requiring a compact lifting bay.
- Compatible passenger cars within the 3,000 kg capacity and approved lifting points.
Installation requirements
Requires a 220 V single-phase power supply with electrical protection suitable for the 2.2 kW motor. Install on a level floor that meets the manufacturer's supporting and fixing requirements.
The product table lists a 2,050 mm platform length and 110 mm minimum height, whereas the drawing shows 2,030 mm and 105 mm. Confirm the final dimensions before planning the installation space.
The lift weighs 650 kg and requires suitable unloading and handling equipment. Check the hydraulic system, safety locks and limit switch before commissioning.
Installation and safety inspections must be completed by qualified professionals in accordance with the EQT-30SSE-220 manual.
